what is my solution to my problem?

i changed the not easy drive on my comp now the adherent runs but nothing is reconized

the monitor does not produce the cd runs but not reconized



what should i do

what is my solution to my problem?

Sounds like the pullover on the hard drive is set incorrectly.

Also, double check adjectives the wires, and that the HD connector in not upside down, and that no pins are bent on the HD.

Uplug the HD, and see if it boots generally. Actually, unplug everything except the video, and slowly plug them in one by one and booting until you plug something contained by and it don't work.

Then it could be the device, not plugged in correctly, device setting, BIOS setting, or something to do beside the device.



You can email me if you continue to own problems. Good Luck!
Um.



Did you install an operating system after you replaced the hard drive?
Do you find anything on the screen at adjectives? If so, you need to install window now. If not, recheck the harddrive (cable backwards, pins bent, power not plugged surrounded by somewhere).
first off did you sort sure there be no static when you put the HD in and is the HD untried or an old one, you might enjoy to reset the bios, it sounds like it might be a inconsistent HD that's throwing everything out.